Monday, January 5, 2009

Tay Du Ky Journey To The West Online

REPAIRING THE 21, 51 and 61

And we, finally, a series of fountain pen that marked a milestone in the history of writing with pen
Undoubtedly, there is a before and after of Parker 51, which was probably the fountain pen more copies of the story, and it has a cause, its design


We can see from the illustration a red herring detailed system using both 21, such as 51, and 61, except tiny differences in the measures are almost equal
On the far left, we see the hull of the pen, which is the part that covers the entire system, secondly, we can see how the whole system is to remove the hull
If we remove the feeder (in third place with pen, and in fourth place without it), we see that has a thin transparent tube on the back, used to improve the flow of ink to write
The fifth figure corresponds to the core on which any weapon which has, as seen in the last figure, two parts
The darker core is itself, which is nothing more than a hub with the appropriate measures which should be tapped in the back of the bag is placed which acts as a rubber ink tank, and does not appear in the image
the transparent, it is extremely important, its role ink is retained in its interstices, to ensure a small amount of ink always available for the start of writing is immediate, even if the fountain pen estubo inactive for a considerable time
Considering that completely covers the hull of this piece, and almost entirely to pen and feed, we conclude that no cause evaporation of ink, and if there were, it would be minimal and slow
The most amazing of all this is that despite over half a century old, the parts that make up these fountain pen , did not lose their quality in the most minimal not resected, not deformed, not spent (except feathers), even today days in all I have, (ten or twelve) , the pieces are fitting "to pressure" are not big or small, just enter ...¡¡¡ amazing!
Unless it takes a change of pen, repairs, disarmament will not pass on (or not) and a cleansing bath
The only possible difficulty , could be removing the hull, this will to do with two clamps, which are should cover the jaws leather, or other material that prevents the mark or scratch the hull as well threaded core
If it is impossible to loosen it is convenient to use dry heat for it, the appropriate tool is a hair dryer, without fear the hull is deformed
On the contrary, it is not advisable to use hot water because this if could distort the plastic
For the rest of the parts are easily removable by hand, but remember that should practice first with discarded items to gain some practice

plumas.caito @ gmail.com