The most important thing in putting together a set pen-feeder is mounting both within the nozzle
We have seen that feeders have one or more slots drop of ink, and insert the assembly, the first thing to consider is that the vent hole is firmly focused on the slot drop of ink, because it will hamper the entry of air and therefore, the ink drop
A then we check that between the pen and the power supply has a small space and even, nor too wide nor too tight
The way to check pass a pre-strip is cut from a radiograph , or a strip of cardboard, which will to slide between pen and feeder should be aware that if the food is wet the strip of cardboard is moisten and should change, the idea is to run with some difficulty and evenly
the case that there was much or little space between them, or the space between them is not even proceed as follows
placed in a small bowl a little water and boil, immerse in boiling water feeder (with tweezers or something similar), for approximately 10 seconds, then quickly put pen to and held down while placing under cold running water , until cool Repeat this as many times as necessary
This will that fits the plastic to the shape of the pen, take into account that the flow is directly proportional to the space between both parts, more space, more flow
One way to increase the flow (and stroke), without disassembling anything, is separating (only slightly) the arms of the boom, this is achieved by introducing among them the cuting edge of a , razor blade or scalpel and
prying This operation must be very careful not to twist or decentering means of Iridium
areas remember that surgeons practicing with corpses
plumas.caito @ gmail.com
0 comments:
Post a Comment