Sunday, November 30, 2008

What Does Each Colour Of Gel Bracelet Mean ?

REPAIRS Feeders _ _ Part IV Part III



do work well to achieve a pen problematic, the first thing is to know the theory of operation of the food is part must provide enough ink in the moments that you write, you must prevent the spillage in moments of rest, regardless of the position in which is holding the pen, and must always be a quantity of ink on the tip of the pen to start writing without delay the provision of ink is achieved by grooves that communicate to pen with the tank, usually two, one to lower ink and another to air rising, because if air rises into the tank, no low ink to the pen for no leakage when in repose, generally, feeders have a very finite slots (capillaries), which for a physical phenomenon, they return to the ink tank and finally to achieve a small ink on the tip, have these multiple slots that can be seen in the illustration if we click on the picture is enlarged allowing you to see in detail the three feeders in the first, which is very modern, we see a large slotted cross, a fine capillary channel to the tip, and a chamfer from the beginning of the slot until the front end at the top of the drawer, just below the boom, this chamfer allows a greater flow of ink at the top of the food in the second it is not so modern, but it is very old, we see that the grooving is not as heavy as the first and has two notches all along, to allow good air intake and a little more ink retention volume, the capillary is also seen throughout the feeder and transverse grooves on the end to retain ink and Finally, the last, which is the oldest of all, there are very few slots and two large longitudinal chamfer, you can also appreciate the lack of hair, and instead a large ink drop chute, This, plus the two large chamfer, will produce, surely sweating in the plume But this is only theory, the practice is not going to prove that an ancient food with technical flaws, sometimes it works so well as one of the last generation, because if you have good design and we know every part of the feeder, will give us more resources at the time of repairs

plumas.caito @ gmail.com /

0 comments:

Post a Comment